Rodrigo, I ran into some problems with this exercise. I ma using Rhino 5 and GH ...

Question

Rodrigo, I ran into some problems with this exercise. I ma using Rhino 5 and GH ...

almost 9 years ago by Chakris

Rodrigo, I ran into some problems with this exercise. I ma using Rhino 5 and GH 1. When I go to generate the negative points and circle on the X axis, the copied components (slider with formula f*-1) gives me an error and nothing get generated. Once I do the entire definition it looks as though only half of everything is done.

Rodrigo Medina Garcia · Accepted Answer

Hi Chakris thanks for posting you question over here , there was a change on the last Grasshopper version for using expressions on the components inputs so now all expression should be set up using the x variable so instead  (f*-1)  it should be (x*-1) .Here is the Grasshopper Thread.http://www.grasshopper3d.com/f...

Forum

Parametric Modeling

Rodrigo, I ran into some problems with this exercise. I ma using Rhino 5 and GH ...

1 Answers

Parametric Modeling

Rodrigo, I ran into some problems with this exercise. I ma using Rhino 5 and GH ...

1 Answers