ExtrudeCrv - Solide=Yes and Cap are they the same?

Question

After you extruded the curve, there was a gap in the wall and you used the cap command to fill the gap. (4:30).
Is it the same as turning the solid option to yes in the extrude crv command?
Thanks.

Awais Rauf · Accepted Answer

Had I the patience to wait a minute before asking the question, my doubt would've been cleared. Thanks for being clear and concise in the videos.

Forum

Explicit Modeling

ExtrudeCrv - Solide=Yes and Cap are they the same?

1 Answers

Explicit Modeling

ExtrudeCrv - Solide=Yes and Cap are they the same?

1 Answers