Hi! I know it's a bad-ass stair case right =) Remember that the goal of this course is not so much to recreate the villa in its exact details, but more about the process of how to setup your scene for architectural purposes. That being said, what are you missing from the stair case, the handrails or the smooth bottom part? I could make some steps to create those if they're helpful. Cheers!

The curved underside. I tried using the Sweep 2 rail command which got me close the the proper result. But the geometry for the stairs punctures the surface created by the sweep command. For the black hand rail, I would use single lines and then use the pipe command to give them shape.

Hi, this is how I would do it:1) Select all the bottom parts of the stair steps2) Loft them together to create the bottom part3) Delete the outer railing4) Select the outside surface edge from the just created bottom part5) Extrude that edge 1.2 m upwards6) Offset this surface 0.05 m inwardsFor the handrail, that is also how I would do it, you can use the same edge we used for our railing. Just copy it upwards and run the pipe command and tweak its position a bit.Good luck!

Hi, this is how I would do it:1) Select all the bottom parts of the stair steps2) Loft them together to create the bottom part3) Delete the outer railing4) Select the outside surface edge from the just created bottom part5) Extrude that edge 1.2 m upwards6) Offset this surface 0.05 m inwardsNow for the handrail, that is also how I would do it, you can use the same edge we used for our railing. Just copy it upwards and run the pipe command and tweak its position a bit.Good luck!

Hi, this is how I would do it:1) Select all the bottom parts of the stair steps.2) Loft them together to create the bottom part.3) Delete the outer railing.4) Select the outside surface edge from the just created bottom part.5) Extrude that edge 1.2 m upwards.6) Offset this surface 0.05 m inwards.Now for the handrail, that is also how I would do it, you can use the same edge we used for our railing. Just copy it upwards and run the pipe command and tweak its position a bit.Good luck!